Page 217 - ZPL II Programming Guide
P. 217
ZPL Commands 197
^JJ
Parameters Details
d = application label Accepted Values:
error mode e = error mode—the printer asserts the Service Required
signal (svce_req - pin 10) on the application port, enters
into Pause Mode, and displays an error message on the
LCD.
f = Feed Mode—a blank label prints when the web is not
found where expected to sync the printer to the media.
Default Value: f
e = reprint mode Accepted Values:
e = enabled—the last label reprints after the signal is
asserted. If a label is canceled, the label to be reprinted
is also canceled. This mode consumes more memory
because the last printed label is not released until it
reprints.
d = disabled—printer ignores the Reprint signal.
Default Value: d
f = ribbon low mode Accepted Values:
e = enabled – printer warning issued when ribbon low.
d = disabled – printer warning not issued when ribbon low.
Default Value: e
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
