Page 287 - ZPL II Programming Guide

ZPL Commands 267
^SS

^SS

Set Media Sensors

Description The ^SS command is used to change the values for media, web, ribbon, and
label length set during the media calibration process. The media calibration process is
described in your specific printer’s user’s guide.

Format ^SSw,m,r,l,m2,r2,a,b,c
This table identifies the parameters for this format:

Parameters Details

w = web (three-digit Accepted Values: 000 to 100
value) Default Value: value shown on the media sensor profile or
configuration label

m = media (three- Accepted Values: 000 to 100
digit value) Default Value: value shown on the media sensor profile or
configuration label
r = ribbon (three- Accepted Values: 000 to 100
digit value) Default Value: value shown on the media sensor profile or
configuration label
l = label length (in Accepted Values: 0001 to 32000
dots, four-digit Default Value: value calculated in the calibration process
value)
m2 = intensity of Accepted Values: 000 to 100
media LED Default Value: value calculated in the calibration process
(three-digit
value)
r2 = intensity of Accepted Values: 000 to 100
ribbon LED Default Value: value calculated in the calibration process
(three-digit
value)
a = mark sensing Accepted Values: 000 to 100
(three-digit Default Value: value calculated in the calibration process
value)

b = mark media Accepted Values: 000 to 100
sensing (three- Default Value: value calculated in the calibration process
digit value)
c = mark LED Accepted Values: 000 to 100
sensing (three- Default Value: value calculated in the calibration process
digit value)

9/15/06 ZPL II Programming Guide 45541L-004 Rev. A