Page 286 - ZPL II Programming Guide

266 ZPL Commands
^SR

^SR

Set Printhead Resistance

Description The ^SR command allows you to set the printhead resistance.

Format ^SR####
This table identifies the parameters for this format:

Parameters Details

#### = resistance Accepted Value: 0488 to 1175
value (four-digit Default Value: last permanently saved value
numeric value)

Comments To avoid damaging the printhead, this value should be less than or equal to the
value shown on the printhead being used. Setting a higher value could damage the printhead.

Note • New printer models automatically set head resistance.

45541L-004 Rev. A ZPL II Programming Guide 9/15/06