Page 290 - ZPL II Programming Guide

270 ZPL Commands
^SX

^SX

Set ZebraNet Alert

Description The ^SX command is used to configure the ZebraNet Alert System.

Format ^SXa,b,c,d,e,f
This table identifies the parameters for this format:

Note • The values in this table apply to firmware V48_12_4 and above.

Parameters Details
a = condition type Accepted Values:
A = paper out
B = ribbon out
C = printhead over-temp
D = printhead under-temp
E = head open
F = power supply over-temp
G = ribbon-in warning (Direct Thermal Mode)
H = rewind full
I = cut error
J = printer paused
K = PQ job completed
L = label ready
M = head element out
N = reserved
O = reserved
P = power on
Q = clean printhead
R = media low
S = ribbon low
T = replace head
U = battery low
V = RFID error (in RFID printers only)
W = all errors (in RFID printers only)
* = all errors (in non-RFID printers)
Default Value: if the parameter is missing or invalid, the command
is ignored

45541L-004 Rev. A ZPL II Programming Guide 9/15/06